4'' WPS-CA/EP102 Waston Type Pulse Jet Solenoid Valve Diaphragm

4'' WPS-CA/EP102 Waston Type Pulse Jet Solenoid Valve Diaphragm

The electromagnetic pulse valve is composed of electromagnetic pilot operator, diaphragm and valve body. Due to difference of pressure acting on two sides of the diaphragm, the diaphragm is pressed closely against the outlet of valve to keep the valve stays in "closed" position.

When energized by an electric signal from the controller, the electromagnetic armature will move to open the discharge opening of back cavity. The compressed air in back cavity bursts out to relief pressure and pressurized air in front cavity pushes up the diaphragm to open the main outlet of valve, then the electromagnetic pulse valve opens and starts to blow.

When the signal disappears and the spring works immediately to send the pilot operator back to its original position and close the discharging opening. The diaphragm will close the passage by the effect of the pressure in the front cavity and the spring. The pulse valve stops blowing.

The orifice in the diaphragm damps the airflow when the armature is lifting up for releasing the pressure. When the discharge hole closed, the pressure gas will fill into the front cavity to close the passage by the diaphragm. The pulse valve stops blowing.

Video of Diaphragm For 4'' WASTON Pulse Valve:

Dimension of Diaphragm For 4'' WASTON Pulse Valve:

Big Diaphragm For 4'' WASTON Pulse Valve

Small Diaphragm For 4'' WASTON Pulse Valve

Ordering Code of Diaphragm For WASTON Pulse Valve:

Pictures of Solenoid Valve Membrane Production:

More Products For WASTON Pulse Valve for you to choose:

Solenoid Coil	Solenoid Armature	Pulse Controller

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt

√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for

√ Contact us if you are doing designing

Welcome to your any question and inquiry!