|Place of Origin:||China|
|Minimum Order Quantity:||3 pc|
|Price:||USD2.00-10.00 per pc|
|Packaging Details:||inner boxes,cartons,pallets|
|Delivery Time:||7 working days|
|Payment Terms:||L/C, T/T, Western Union|
|Supply Ability:||100000pcs per month|
|Size:||3/8''||Type:||Two-position Two-way Solenoid Valve|
3/8" Brass Material Standard 2/2 Way Water Solenoid Valve 2W040-10
2W series water solenoid valve made of 100% pure brass,allow working medium of air,water,oil and gas.This series of valves, using direct - acting diaphragm structure pressure - free start, expanding its range of use.In addition, the plate-type diaphragm structure is adopted for reliable opening and closing, which enhances the service life of the product.The use of laminated coils improves the safety of the product in a wide variety of environments.
NC:it will be open when power on,and close when power off.
NO:it will be closed when power on,and open when power off.
|Motion Pattern||Direct Drive Type|
|Type||Normal Close Type|
|Aperture of Flow Rate||4|
|Joint Pipe Bore||3/8”|
|Operating Temperature Rang||-5~80|
|Operation Fluid Viscosity||20 CST(below)|
|Working Pressure(kgf/cm||Gas:0~7, Oil:0~5, Air:0~7, Water:0~5|
|Material of Oil Seal||NBR,EPDM Or Viton|
The drawings of 2W040-10
The picture of diaphragm of 2W040-10
The 100% pure brass coil of 2W040-10
1.The threaded interface around the ribbons
2.According to the direction of access to the solenoid valve
3.According to the standard access power supply
4.Detection of sealing and circuit
Brass solenoid water valve working principle
Brass, electromagnetic valve, solenoid valve has closed cavity open a hole in different position, every hole leads to different tubing, cavity valve is among, both sides are two electromagnets, which face the magnet coil electricity body will be attracted to which side, by controlling the movement of the valve body is blocking or different oil discharge hole leakage, and oil hole is always open, hydraulic fluid will enter the different oil drain, and then through the oil pressure to push the cylinder piston, piston drives the piston rod, piston rod drive mechanism. In this way, the mechanical motion is controlled by controlling the current flow of the electromagnet.
electromagnetic valve installation using:
1, before installation should refer to the instruction manual of the product, whether to meet your demand.
2, line should be rinsed clean before using, medium to clean the filters should be installed, and not to prevent impurities may not impair the normal work of the solenoid
3, the electromagnetic valve is generally one-way work, can't reverse loading, the movement direction of the arrow on valve is line, must be consistent.
4, the electromagnetic valve installation general level of the valve body, vertical coil, and some products can be installed arbitrarily, but best vertical when conditions
permit, to increase service life.
5, the electromagnetic valve in the frozen place to work shall be heat treated, or set the heat preservation measures.
6, the electromagnetic coil lead wire (connector) connection, should confirm whether firm, join electrical components contact should not shake, loose will cause
electromagnetic valve does not work.
7, continuous production of solenoid valve, had better use the bypass, easy maintenance, does not affect production.
8, long after discontinuation of solenoid valve, should be no clear condensation rear can use. When unpick and wash all parts are to put away again restorable installed in
9, has the unclear place, please contact with little company, serve you wholeheartedly.
Contact Person: Cooper